Stanat 4" x 6" 2-High Rod Rolling Mill - Dual Head

説明

Stanat 4" x 6" 2-High Rod & Wire Rolling Mill - Dual-Head Configuration

Overview:
This mill is configured with two rolling heads for progressive rod/wire reduction. The mill was taken offline from a running production environment and is well suited for R&D, prototype development, specialty alloy trials, and small-batch rod and wire processing.

The machine is equipped with approximately 4" diameter x 6″ face width rolls in each head and is driven by a 7.5 HP main drive motor.

Rolling Configuration & Pass Schedule:
This mill is arranged with two independent rolling heads utilizing approximately 27 modified-square grooves across both heads for progressive rod/wire reduction:

Primary Head - Larger Grooves:
Approximately 8 grooves, estimated to cover reductions from approximately 0.750" down to 0.300" with the rolls fully closed.

Secondary Head - Smaller Grooves
Approximately 19 grooves, estimated to cover reductions from approximately 0.300" down to 0.060" with the rolls fully closed.

Note: Groove sizes and working ranges are approximate estimates with the rolls fully closed. Larger rod/wire may be accommodated by opening the rolls depending on material condition and reduction strategy. Actual achievable reductions and pass percentages will vary with material, temper, lubrication, roll condition, and annealing practice.

Applications:
Research & development environments
Specialty alloy rod/wire trials
Pilot-scale material development
Small production runs requiring staged reduction